Brill E-Books

 Contact Angle, Wettability and Adhesion, Volume 5

Contents

• • Preliminary Material (i-viii)   (198K)
    • Jump to section:
    • Contents
    • Preface
  • Effects Of Surface Structure On The Behavior Of A Heated Contact Line (1-24) by M. Ojha, G. Dalakos, S. Panchamgam, P. C. Wayner Jr. and J. L. Plawsky   (2M)
    • Jump to section:
    • 1. Introduction
    • 2. Experimental Set-Up
    • 3. Results And Discussion
    • 4. Conclusions
    • References
  • Apparent Solidification Contact Angles Of Micro-Droplets Deposited On Solid Surfaces (25-46) by Ri Li, N. Ashgriz, S. Chandra, J. R. Andrews and S. Drappel   (4M)
    • Jump to section:
    • 1. Introduction
    • 2. Experimental Details
    • 3. Results
    • 4. Discussion
    • 5. Conclusions
    • References
  • Microscopic Wettability Of Softwood Tracheid Cell Walls: Effects Of Wall Sculpturing, Sap Solutes, And Drying (47-58) by M. M. Kohonen   (5M)
    • Jump to section:
    • 1. Introduction
    • 2. Materials And Methods
    • 3. Results And Discussion
    • 4. Conclusions
    • References
  • The Effect Of Binary Fatty Acids Systems On Partitioning, IFT And Wettability Of Calcite Surfaces (59-72) by O. Karoussi and A. A. Hamouda   (750K)
    • Jump to section:
    • 1. Introduction
    • 2. Experimental
    • 3. Results And Discussion
    • 4. Conclusions
    • References
  • Mechanistic Modeling Of Dynamic Vapor-Liquid Interfacial Tension In Complex Petroleum Fluids (73-94) by S. C. Ayirala and D. N. Rao   (1M)
    • Jump to section:
    • 1. Introduction
    • 2. Objectives
    • 3. Results And Discussion
    • 4. Summary And Conclusions
    • References
  • Influence Of Ambient Humidity On The Apparent Surface Free Energy Of Poly (Methyl Methacrylate) (PMMA) (95-112) by L. Holysz, E. Chibowski and K. Terpilowski   (1M)
    • Jump to section:
    • 1. Introduction
    • 2. Experimental
    • 3. Results And Discussion
    • 4. Conclusion
    • References
  • Wettability Measurements And Cleanliness Evaluation Without Substantial Cost (113-138) by J. B. Durkee and A. Kuhn   (2M)
    • Jump to section:
    • 1. Introduction
    • 2. Two Approaches To Cleanliness Evaluation
    • 3. Wettability And Surface Cleanliness
    • 4. Cleanliness Evaluation With Limited Equipment
    • 5. Thewater-Break Test
    • 6. Foundation Of Wettability Measurements
    • 7. Bikerman’s Equation
    • 8. Low-Cost Equipment For Wettability Measurements
    • 9. Choice Of Wetting Liquid
    • 10. Summary And Conclusions
    • References
  • Wettability Parameters Controlling The Surface Cleanability Of Stainless Steel (139-152) by L. Boulangé-Petermann, J.-C. Joud and B. Baroux   (3M)
    • Jump to section:
    • 1. Introduction
    • 2. Materials And Methods
    • 3. Role Of The Surface Polarity
    • 4. Highly Roughened Surfaces
    • 5.Water Contact Angle Hysteresis And Cleaning
    • 6. Understanding Soil (Oil) Removal From Solid Surfaces
    • 7. Conclusions
    • References
  • Functional Topcoats On Coated Textiles For Improved Or Self-Attained Cleanability (153-172) by T. Bahners, L. Prager, B. Marquardt and E. Schollmeyer   (6M)
    • Jump to section:
    • 1. Introduction
    • 2. The Process Of Photochemically Induced Mirco-Folding
    • 3. Experimental
    • 4. Results And Discussion
    • 5. Summary
    • References
  • Wetting And Adhesion In Fibrous Materials: Stochastic Modeling And Simulation (173-190) by W. Zhong, N. Pan and D. Lukas   (2M)
    • Jump to section:
    • 1. Introduction
    • 2. Liquid Wetting/Wicking In Fibrous Structures
    • 3. Interface Between Fiber And Resin In Composite Materials
    • 4. Conclusion
    • References
  • Adhesion Of Hydrophobizing Agents: A Comparison Of Values Determined Angle Contact And The JKR Approaches (191-206) by J. Lindfors, J. Laine and P. Stenius   (1M)
    • Jump to section:
    • 1. Introduction
    • 2. Experimental
    • 3. Results
    • 4. Discussion
    • 5. Conclusions
    • References
  • Wettability Aspects And The Improvement Of Adhesion Of UV Curable Powder Coatings On Polypropylene Substrates (207-228) by M. Wouters and P. Castell Muixí   (1M)
    • Jump to section:
    • 1. Introduction
    • 2. Experimental
    • 3. Results And Discussion
    • 4. Conclusions
    • References
  • Modulation Of The Surface Properties Of Reactive Polymers By Photo-Fries Rearrangement (229-238) by S. Temmel, T. Höfler and W. Kern   (544K)
    • Jump to section:
    • 1. Introduction
    • 2. Experimental Section
    • 3. Results And Discussion
    • 4. Conclusions
    • References
  • Effect Of Grafting Efficiency On Peel Strength, Contact Angle, Particle Size And Viscosity Of Butyl Acrylate–PUD Hybrid Adhesives For Plastic Laminates (239-252) by S. K. Patel, R. N. Jagtap and N. Khatik   (700K)
    • Jump to section:
    • 1. Introduction
    • 2. Experimental
    • 3. Results And Discussion
    • 4. Conclusions
    • References
  • Cell Adhesion To Polystyrene Substrates: Relevance Of Interfacial Free Energy (253-268) by A. Carré and V. Lacarrière   (828K)
    • Jump to section:
    • 1. Introduction
    • 2. Experimental
    • 3. Results
    • 4. Conclusion
    • References
    • Appendix 1. Composition Of The Fetal Bovine Serum
    • Appendix 2. Adsorption Of BSA At The Octane/Ham F-12 Culture Medium Interface
  • Superhydrophobic Aluminum Surfaces Obtained (269-278) by Chemical Etching By D. K. Sarkar and M. Farzaneh   (829K)
    • Jump to section:
    • 1. Introduction
    • 2. Experimental
    • 3. Results And Discussion
    • 4. Conclusions
    • References
  • Effect Of Temperature On Superhydrophobic Zinc Oxide Nanotowers (279-286) by N. Saleema, D. K. Sarkar and M. Farzaneh   (1M)
    • Jump to section:
    • 1. Introduction
    • 2. Experimental Details
    • 3. Results And Discussion
    • 4. Conclusion
    • References
  • Superhydrophobic Properties Of Silver Coated Copper (287-294) by A. Safaee, D. K. Sarkar and M. Farzaneh   (661K)
    • Jump to section:
    • 1. Introduction
    • 2. Experimental
    • 3. Results And Discussion
    • 4. Conclusion
    • References
  • Surfactants Adsorption At Hydrophobic And Superhydrophobic Solid Surfaces (295-308) by M. Ferrari   (2M)
    • Jump to section:
    • 1. Introduction
    • 2. Surfactants Adsorption At Hydrophobic Surfaces
    • 3. Surfactant Adsorption At Superhydrophobic Surfaces
    • 4. Surfactants Adsorption At Superhydrophobic Surfaces In Liquid-Liquid Systems
    • 5. Conclusions
    • References